Procedures
viii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP-D211 Convert a Two-Fiber MS-SPRing to a Four-Fiber MS-SPRing Automatically 13-16
NTP-D159 Modify an MS-SPRing 13-18
Add and Remove Nodes 14-1
NTP-D353 Add an MS-SPRing Node 14-2
NTP-D213 Remove an MS-SPRing Node 14-7
NTP-D105 Add an SNCP Node 14-10
NTP-D106 Remove an SNCP Node 14-12
NTP-D280 Add a Node to a Linear ADM Manually 14-14
NTP-D337 Add a Node to a Linear ADM Using the Wizard 14-15
NTP-D322 Remove an In-Service Node from a Linear ADM 14-18
Maintain the Node 15-1
NTP-D107 Inspect and Maintain the Air Filter 15-2
NTP-D108 Back Up the Database 15-5
NTP-D109 Restore the Database 15-6
NTP-D328 View and Manage OSI Information 15-8
NTP-D163 Restore the Node to Factory Configuration 15-9
NTP-D312 Viewing the Audit Trail Records 15-10
NTP-D214 Off-Load the Audit Trail Record 15-12
NTP-D313 Off-Load the Diagnostics File 15-13
NTP-D231 Initiate or Clear an External Switching Command 15-14
NTP-D112 Clean Fiber Connectors 15-15
NTP-D153 Reset a Card Using CTC 15-16
NTP-D215 View G-Series Ethernet Maintenance Information 15-16
NTP-D266 View E-Series Ethernet Maintenance Information 15-17
NTP-D233 Change the Node Timing Reference 15-18
NTP-D265 View the ONS 15454 SDH Timing Report 15-18
NTP-D229 Replace an In-Service Cross-Connect Card 15-21
NTP-D230 Replace the Fan-Tray Assembly 15-22
NTP-D345 Edit Network Element Defaults 15-25
NTP-D346 Import Network Element Defaults 15-26
NTP-D347 Export Network Element Defaults 15-27
Power Down the Node 16-1
NTP-D114 Power Down the Node 16-1
To Next Page
Loading...
