Procedures
xiii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D167 Add a Static TID to NSAP Entry to the TARP Data Cache 18-57
DLP-D168 Remove a Static TID to NSAP Entry from the TARP Data Cache 18-57
DLP-D169 Add a TARP Manual Adjacency Table Entry 18-58
DLP-D171 Provision OSI Routers 18-59
DLP-D172 Provision Additional Manual Area Addresses 18-60
DLP-D173 Enable the OSI Subnet on the LAN Interface 18-60
DLP-D174 Create an IP-Over-CLNS Tunnel 18-62
DLP-D175 Remove a TARP Manual Adjacency Table Entry 18-63
DLP-D176 Convert E1-N-14 Cards From 1:1 to 1:N Protection 18-63
DLP-D177 Convert DS3i-N-12 Cards From 1:1 to 1:N Protection 18-65
DLP-D178 Change the OSI Routing Mode 18-66
DLP-D179 Edit the OSI Router Configuration 18-67
DLP-D180 Edit the OSI Subnetwork Point of Attachment 18-68
DLP-D181 Edit an IP-Over-CLNS Tunnel 18-69
DLP-D182 Delete an IP-Over-CLNS Tunnel 18-70
DLP-D183 View IS-IS Routing Information Base 18-70
DLP-D184 View ES-IS Routing Information Base 18-71
DLP-D185 Manage the TARP Data Cache 18-72
DLP-D186 Provision a Low-Order VC11 Circuit Source and Destination 18-73
DLP-D187 Provision a Low-Order VC11 Circuit Route 18-74
DLP-D188 View CE-Series Ethernet and POS Ports Statistics PM Parameters 18-75
DLP-D189 Verify that a 1+1 Working Slot is Active 18-77
DLP-D190 View CE-Series Ethernet and POS Ports Utilization PM Parameters 18-78
DLP-D191 Delete a Card 18-79
DLP-D192 View CE-Series Ethernet and POS Ports History PM Parameters 18-80
DLP-D193 Grant Superuser Privileges to a Provisioning User 18-81
DLP-D194 Clear an MS-SPRing Force Ring Switch 18-82
DLP-D195 Verify Timing in a Reduced Ring 18-82
DLP-D196 Delete an MS-SPRing from a Single Node 18-83
DLP-D197 Initiate an SNCP Force Switch 18-84
DLP-D198 Clear an SNCP Force Switch 18-85
DLPs D200 to D299 19-1
DLP-D201 Apply a Lock-On 19-1
DLP-D202 Apply a Lockout 19-2
DLP-D203 Clear a Lock-On or Lockout 19-3
To Next Page
Loading...
