Tasks
ix
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D241 Clear an MS-SPRing Manual Ring Switch 19-44
DLP-D242 Create an MS-SPRing on a Single Node 19-45
DLP-D243 Create a VLAN 19-46
DLP-D244 Use the Reinitialization Tool to Clear the Database and Upload Software (Windows) 19-47
DLP-D245 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX) 19-49
DLP-D246 Provision E-Series Ethernet Card Mode 19-50
DLP-D247 Change an STM-N Card 19-51
DLP-D248 Delete VLANs 19-52
DLP-D249 Provision IP Settings 19-52
DLP-D250 Set Up or Change Open Shortest Path First Protocol 19-56
DLP-D251 Set Up or Change Routing Information Protocol 19-58
DLP-D254 TCC2/TCC2P Card Active/Standby Switch Test 19-59
DLP-D255 Cross-Connect Card Side Switch Test 19-60
DLP-D256 View Ethernet Statistics PM Parameters 19-61
DLP-D257 View Ethernet Utilization PM Parameters 19-62
DLP-D258 View Ethernet History PM Parameters 19-63
DLP-D259 Refresh Ethernet PM Counts at a Different Time Interval 19-63
DLP-D260 Set Auto-Refresh Interval for Displayed PM Counts 19-64
DLP-D261 Refresh PM Counts for a Different Port 19-65
DLP-D262 Filter the Display of Circuits 19-65
DLP-D263 Edit SNCP Dual-Ring Interconnect Circuit Hold-Off Timer 19-67
DLP-D264 Provision a J1 Path Trace on Circuit Source and Destination Ports 19-68
DLP-D265 Change the Login Legal Disclaimer 19-71
DLP-D266 Change IP Settings 19-72
DLP-D268 Apply a Custom Network View Background Map 19-73
DLP-D269 Enable Dialog Box Do-Not-Display Option 19-74
DLP-D271 Change Node Security Policy on a Single Node 19-74
DLP-D272 Change Node Security Policy on Multiple Nodes 19-76
DLP-D273 Modify SNMP Trap Destination 19-77
DLP-D293 Perform a Manual Span Upgrade on a Two-Fiber MS-SPRing 19-78
DLP-D294 Perform a Manual Span Upgrade on a Four-Fiber MS-SPRing 19-79
DLP-D295 Perform a Manual Span Upgrade on an SNCP 19-80
DLP-D296 Perform a Manual Span Upgrade on a 1+1 Protection Group 19-81
DLP-D297 Perform a Manual Span Upgrade on an Unprotected Span 19-82
DLP-D298 Check the Network for Alarms and Conditions 19-83
To Next Page
Loading...
