EasyManua.ls Logo

Cisco ONS 15454 SDH - Page 50

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Tasks
x
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D299 Initiate an MS-SPRing Span Lockout 19-84
DLP-D300 Clear an MS-SPRing Span Lockout 20-1
DLP-D301 Initiate an MS-SPRing Manual Ring Switch 20-2
DLP-D303 Initiate an MS-SPRing Force Ring Switch 20-3
DLP-D309 View Ethernet MAC Address Table 20-4
DLP-D310 View Ethernet Trunk Utilization 20-5
DLP-D311 Provision a Half Circuit Source and Destination on an MS-SPRing or 1+1 Node 20-5
DLP-D312 Provision a Half Circuit Source and Destination on an SNCP Ring 20-6
DLP-D314 Assign a Name to a Port 20-7
DLP-D315 Log Out a User on a Single Node 20-7
DLP-D316 Log Out a User on Multiple Nodes 20-8
DLP-D318 Provision a Low-Order VC3 Circuit Source and Destination 20-9
DLP-D321 Open the FMEC Cover 20-10
DLP-D322 Remove the FMEC Cover 20-11
DLP-D324 Install Alarm Cables on the MIC-A/P 20-12
DLP-D325 Install Timing Cables on the MIC-C/T/P 20-15
DLP-D326 Install LAN Wires on the MIC-C/T/P 20-16
DLP-D328 Install 75-Ohm E-1, E-3, or STM-1 Coaxial Cables 20-17
DLP-D329 Install 120-Ohm E-1 Cables with DB-37 Connectors to the FMECs 20-18
DLP-D330 Install 120-Ohm E-1 Cables with Molex 96-Pin LFH Connectors 20-20
DLP-D332 Install the TCC2/TCC2P Cards 20-22
DLP-D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G Cards 20-25
DLP-D334 Install the Alarm Interface Controller–International Card 20-26
DLP-D335 Install GBIC or SFP/XFP Devices 20-28
DLP-D336 Remove GBIC or SFP/XFP Device 20-32
DLP-D337 Install Fiber-Optic Cables for SNCP Configurations 20-33
DLP-D338 Install Fiber-Optic Cables for MS-SPRing Configurations 20-37
DLP-D365 Change Line and Threshold Settings for E1-N-14 or E1-42 Cards 20-39
DLP-D340 Change Line and Threshold Settings for the E3-12 Cards 20-43
DLP-D341 Change Line and Threshold Settings for the DS3i-N-12 Cards 20-47
DLP-D342 Change Line and Threshold Settings for the STM1E-12 Card 20-51
DLP-D343 Change SDH Threshold Settings for STM-N Cards 20-54
DLP-D348 View ML-Series Ether Ports PM Parameters 20-56
DLP-D349 View ML-Series POS Ports PM Parameters 20-57
DLP-D353 Provision G-Series Flow Control Watermarks 20-58

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals