Tasks
xi
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D354 Change General Port Settings for the FC_MR-4 Card 20-59
DLP-D355 Change Distance Extension Port Settings for the FC_MR-4 Card 20-61
DLP-D356 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card 20-63
DLP-D357 Verify Pass-Through Circuits 20-64
DLP-D358 Change a Multiplex-Section DCC Termination 20-65
DLP-D359 Change a Regenerator-Section DCC Termination 20-65
DLP-D360 Delete a Regenerator-Section DCC Termination 20-66
DLP-D361 Create a DCC Tunnel 20-66
DLP-D362 Delete a Multiplex-Section DCC Termination 20-68
DLP-D363 Provision Regenerator-Section DCC Terminations 20-68
DLP-D364 Provision Multiplex-Section DCC Terminations 20-71
DLP-D367 Provision a J2 Path Trace on Circuit Source and Destination Ports 20-72
DLP-D368 Manual or Force Switch the Node Timing Reference 20-75
DLP-D369 Clear a Manual or Force Switched Node Timing Reference 20-76
DLP-D370 View Circuit Information 20-76
DLP-D371 View the MS-SPRing Squelch Table 20-80
DLP-D372 Import a Cisco MetroPlanner Configuration File 20-81
DLP-D388 Verify MS-SPRing Extension Byte Mapping 20-81
DLP-D393 Switch Between TDM and DWDM Network Views 20-82
DLP-D420 Install the Public-Key Security Certificate 21-1
DLP-D421 View STM-N PM Parameters 21-2
DLP-D422 Change the JRE Version 21-4
DLP-D424 View Alarm or Event History 21-4
DLP-D425 Create a New or Cloned Alarm Severity Profile 21-6
DLP-D426 Apply Alarm Profiles to Ports 21-9
DLP-D427 Delete Alarm Severity Profiles 21-11
DLP-D428 Modify Alarm, Condition, and History Filtering Parameters 21-12
DLP-D430 Suppress Alarm Reporting 21-15
DLP-D431 Discontinue Alarm Suppression 21-16
DLP-D432 View Port Status on the LCD 21-17
DLP-D433 Run the CTC Installation Wizard for Windows 21-18
DLP-D434 Run the CTC Installation Wizard for UNIX 21-21
DLP-D435 Change the Default Network View Background Map 21-24
DLP-D436 Delete Ethernet RMON Alarm Thresholds 21-25
DLP-D437 Change Node Access and PM Clearing Privilege 21-25
To Next Page
Loading...
