Cisco ONS 15454 SDH - Perform a Terminal (Inward) Loopback on an Intermediate-Node Optical Ports

Tasks
xii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D438 Change Port Settings for the FC_MR-4 Card 21-26
DLP-D441 Create Ethernet RMON Alarm Thresholds 21-28
DLP-D442 Preprovision a Slot 21-33
DLP-D457 Refresh E-Series and G-Series Ethernet PM Counts 21-33
DLP-D458 Monitor PM Counts for a Selected Signal 21-34
DLP-D459 Clear Selected PM Counts 21-36
DLP-D460 View FC_MR-4 Statistics PM Parameters 21-37
DLP-D461 View FC_MR-4 Utilization PM Parameters 21-38
DLP-D462 View FC_MR-4 History PM Parameters 21-39
DLP-D463 Refresh FC_MR-4 PM Counts at a Different Time Interval 21-40
DLP-D465 Create FC_MR-4 RMON Alarm Thresholds 21-40
DLP-D466 Delete FC_MR-4 RMON Alarm Thresholds 21-44
DLP-D468 Create a Two-Fiber MS-SPRing Using the MS-SPRing Wizard 21-44
DLP-D469 Create a Two-Fiber MS-SPRing Manually 21-46
DLP-D470 Manually Route an SNCP Circuit for a Topology Upgrade 21-47
DLP-D471 Automatically Route an SNCP Circuit for a Topology Upgrade 21-48
DLP-D493 Provision the Ethernet Port of the ML-Series Card 21-49
DLP-D494 Provision the POS Port of the ML-Series Card 21-50