Cisco ONS 15454 SDH - Page 793

21-27
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D438 Change Port Settings for the FC_MR-4 Card
Step 1 In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 2 Click the Provisioning > Port tabs.
Step 3 Modify any of the settings described in Table 21-1.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 21-1 FC_MR-4 Card Port Settings
Parameter Description Options
# (Display only) Displays the port number. 1 through 4
Port Name Provides the ability to assign the
specified port a name.
User-defined. Name can be up to
32 alphanumeric/special characters.
Blank by default.
See the “DLP-D314 Assign a Name to a
Port” task on page 20-7.
State Places port in service, out of service, or
out of service-maintenance.
• IS
• OOS
• OOS_MT
Port Rate Selects the Fibre Channel interface.
• 1 Gbps
• 2 Gbps
Link Rate Displays the actual rate of the port. —
Max GBIC
Rate
Displays the maximum Gigabit Interface
Converter (GBIC) rate. Cisco supports
two GBICs for the FC_MR-4 card
(ONS-GX-2FC-SML and
ONS-GX-2FC-MMI). If used with
another GBIC, “Contact GBIC vendor”
appears in this field.
—
Enable Link
Recovery
Enables or disables link recovery if a
local port is inoperable. If enabled, a link
reset occurs when there is a loss of
transport from a cross-connect switch, a
protection switch, or an upgrade.
—