Cisco ONS 15454 SDH - Page 848

Index
IN-16
Cisco ONS 15454 SDH Procedure Guide, R6.0
78-17194-01
exporting 15-27
importing 15-26
restoring 15-9
network map
filtering link display A-8
network map, creating 5-43
network mask, setting through the LCD 17-53
networks
building circuits 6-1, 7-1
changing CTC access 11-2
checking for alarms and conditions 19-83
converting configurations 13-1 to 13-19
customizing CTC view 11-4
disabling autodiscovery 17-51
linear ADM. See linear ADM
MS-SPRing. See MS-SPRing
point-to-point. See point-to-point
setting up basic information 19-52
verifying network turn-up 6-5
Network Time Protocol 4-5
network view
add nodes to map. See domains
apply a custom background image (map) 19-73
changing background 18-36, 19-73
consolidating links in 19-11
creating new users 17-66
customizing 11-4
displaying a link end (drop) point A-11
DWDM A-8
shortcuts A-11
switching between TDM and DWDM 20-82
tasks that can be completed in A-10
TDM A-8
updating circuits with a new node A-11
upgrading a span A-11
node
adding MS-SPRing 14-2
adding to a linear ADM 14-14
adding to a linear ADM using the wizard 14-15
adding to an SNCP 14-10
adding to current session 17-53
adding with the toolbar A-5
applying alarm profiles to 18-18
changing access privileges 21-25
changing management information 11-2
changing security policy 19-74, 19-76
changing the node name 18-32
changing timing 11-6, 15-18
clearing timing reference switch 20-76
configuring for RADIUS authentication 18-5
creating an MS-SPRing on 19-45
date, time, and contact information, setting up 4-4
deleting 17-27, 17-47, A-5
deleting user 18-50, 18-51
disabling security mode 17-80
enabling security mode 17-77
in-service, removing from a linear ADM 14-18
locking security for 17-79
maintaining 15-1 to 15-28
modifying name, date, time, and contact
information
18-32
modifying node ID on an MS-SPRing 17-19
modifying timing source 18-48
powering down 16-1
provisioning SNCP 5-22
removing from an MS-SPRing 14-7
removing from an SNCP 14-12
repairing IP address 17-25
restoring to factory configuration 15-9
switching the timing reference 20-75
turning up 4-1 to 4-14
verifying turn-up 5-2
viewing alarm counts for 9-5
node view
creating users 4-4, 17-65
provisioning IP settings 19-52
setting up timing 17-58
non-ONS node, set IP address 20-65, 20-66