Index
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 Index-7
Beta Draft Confidential
L
Layer 2
tunnel over MPLS, 9-3
configuring, 9-16
module support, 9-4
VPN, 13-1
Leaf Initiated Join (LIJ), 2-4, 21-15
Least OSPF delay, 10-19
Licensing for ATMoMPLS, 8-2 to 8-3
Link Management Interface (LMI)
for RLMI, 15-2
LMI Rev1 for Frame Relay logical ports, 15-2
Link state advertisements
Name LSA suppression, 7-61
VNN OSPF optimized flooding, 7-57 to 7-60
Link Trunk Protocol
overview, 7-3
L-LSP, 9-11, 9-13
LMI Profile ID, 10-66
Load balancing
for SVCs, 17-5
Local
gateway address
setting, 17-49
Local congestion threshold, 5-16
Local discard threshold, 5-16
Logical port
adding, 3-4
Logical ports
configuring attributes, 3-14
configuring fault tolerant PVCs, 14-1
configuring RLMI, 1-4, 15-1, 15-2
deleting, 2-27
non-disruptive attributes, 2-25
PPP, 9-19
service class, 4-34
types of (B-STDX), 4-2
types of (CBX/GX), 2-2
Loss threshold
ILMI, 2-5, 3-35, 4-27
LPort Trunk Conditioning
Rx Conditioning Data, 3-38
Rx Conditioning Mode, 3-39
Rx Conditioning Signal, 3-39
Rx Force Conditioning Mode, 3-39
LSP
properties, 9-14
type, 9-11, 9-13
Lucent Trunk VPN, 8-10
M
Management
PVCs, 11-3
VPI/VCIs, 11-9 to 11-10
Management Permanent Virtual Circuit (MPVC),
11-3
configuring, 11-4
Management redirect PVC
defined, 11-1
Management Soft Permanent Virtual Circuit
(MSPVC), 11-2
configuring, 11-11
described, 11-10
in PNNI environment, 11-11
Management VPCI table entry
adding, 17-16
deleting, 17-18
modifying, 17-18
Management VPI/VCI
defined, 11-1
Maximum burst size (MBS)
definition of, 12-5
PVCs, 10-24, 10-58, 10-79, 12-9, 18-18
Maximum cell delay variation
OPTimum trunks, 3-23
MBS, see maximum burst size
MCR, see minimum cell rate
Minimum Cell Rate (MCR)
class
DS1 (T1) configuration, D-8
IMA group configuration, D-18
class parameters, D-4 to D-17
OC-12c/STM-4 IOM, D-14 to D-17
OC-3c/STM-1 IOM, D-10 to D-13
guarantee, 5-3
traffic descriptor type, 10-24, 10-58, 18-18
Modifying
To Next Page
Loading...
