CHAPTER
8-1
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
8
Transponder and Muxponder Cards
Note The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter describes Cisco ONS 15454 transponder (TXP), muxponder (MXP), GE_XP, 10GE_XP,
ADM-10G cards, as well as their associated plug-in modules (Small Form-factor Pluggables [SFPs or
XFPs]). For installation and card turn-up procedures, refer to the Cisco ONS 15454 DWDM Procedure
Guide. For card safety and compliance information, refer to the Cisco Optical Transport Products Safety
and Compliance Information document.
Note Unless otherwise specified, “ONS 15454” refers to both ANSI and ETSI shelf assemblies.
Chapter topics include:
• 8.1 Card Overview, page 8-2
• 8.2 Safety Labels, page 8-4
• 8.3 TXP_MR_10G Card, page 8-8
• 8.4 TXP_MR_10E Card, page 8-11
• 8.5 TXP_MR_10E_C and TXP_MR_10E_L Cards, page 8-16
• 8.6 TXP_MR_2.5G and TXPP_MR_2.5G Cards, page 8-20
• 8.7 MXP_2.5G_10G Card, page 8-24
• 8.8 MXP_2.5G_10E_C and MXP_2.5G_10E_L Cards, page 8-35
• 8.9 MXP_MR_2.5G and MXPP_MR_2.5G Cards, page 8-44
• 8.10 MXP_MR_10DME_C and MXP_MR_10DME_L Cards, page 8-51
• 8.11 GE_XP and 10GE_XP Cards, page 8-59
• 8.12 ADM-10G Card, page 8-68
• 8.13 Y-Cable and Splitter Protection, page 8-75
• 8.14 Far-End Laser Control, page 8-78
• 8.15 Jitter Considerations, page 8-78
To Next Page
Loading...
Need help?
General
