A-18
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Appendix A      Hardware Specifications
A.5.7    OPT-AMP-C Amplifier Card Specifications
 –
Minimum output power (with one channel): –2 dBm
 –
Maximum power output (standard or extended gain range): 17.5 dBm
 –
Input power range (full channel load): –6 to 3 dBm
 –
Input power range (single channel load): –28 to –19 dBm
 –
Noise figure at G=17dB = 6 dB maximum
 –
Insertion loss (Line RX to OSC TX): 0.3 to 1.8 dB
 –
Insertion loss (Line RX to COM TX): 0.3 to 1.0 dB
 –
Insertion loss (OSC RX to LINE TX): 0.3 to 1.3 dB
 –
Optical connectors: LC-UPC/2
 • Dimensions
 –
Height: 12.65 in. (321.3 mm)
 –
Width: 0.921 in. (23.4 mm) (The dimension of the finger gasket is not included)
 –
Depth: 9.00 in. (228.6 mm)
A.5.7 OPT-AMP-C Amplifier Card Specifications
The OPT-AMP-C amplifier card has the following specifications:
 • Optical characteristics:
 –
Total operating wavelength range: 1529.0 to 1562.5 nm
 –
Gain ripple (peak to valley): 1.2 dB
 –
Gain range: 12 to 24 dB with programmable gain tilt
 –
Extended gain range: 24 to 35 dB with gain tilt uncontrolled
 –
Gain and power regulation over/undershoot: 0.5 dB
 –
Limited maximum output power: 20.5 dBm
 –
Maximum output power (with full channel load): 20 dBm
 –
Minimum output power (with one channel): –2 dBm
 –
Input power (Pin) at full channel load: –15 dBm minimum
 –
Input power (Pin) range at single channel load: –40 to –17 dBm
 –
Noise figure at G
3 
20 dB = 7.6 dB
 –
Insertion loss (Line RX to OSC TX): 0.3 to 1.8 dB
 –
Insertion loss (Line RX to COM TX): 0.3 to 1.0 dB
 –
Insertion loss (OSC RX to LINE TX): 0.3 to 1.3 dB
 –
Optical connectors: LC-UPC/2
 • Dimensions
 –
Height: 12.65 in. (332 mm)
 –
Width: 0.921 in. (23.4 mm) (The dimension of the finger gasket is not included)
 –
Depth: 8.66 in. (220.1 mm)