Cisco ONS 15454 DWDM - Table A-33 MXP_MR_2.5 G;MXPP_MR_2.5 G Card Receiver Trunk Side Specifications

A-56
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Appendix A Hardware Specifications
A.9.4 MXP_MR_2.5G and MXPP_MR_2.5G Card Specifications
– Receiver sensitivity –28 dBm, BER 1 * 10 exp – 12
– Receiver overload is equal to or exceeds –8 dBm
– Receiver maximum reflectance of –27 dB
• Line (client side)
– Bit rate: 200Mbps or 1.06 Gbps to 2.125 Gbps per client
– Code: Scrambled NRZ
– Fiber: Based on SFP (1310-nm single-mode or 850-nm multimode)
– Loopback modes: Terminal and facility
– Connectors: LC
• Transmitter (client side)
– Maximum transmitter output power: –1 dBm
– Minimum transmitter output power: –6 dBm
– Center wavelength: Based on SFP
– Nominal wavelength: Based on SFP
– Transmitter: Based on SFP
• Receiver (client side)
– Maximum receiver level: –1 dBm at BER 1 * 10 exp – 12
– Minimum receiver level: –14 dBm at BER 1 * 10 exp – 12
– Receiver: APD
– Link loss budget: 8 dB minimum, at BER = 1 * 10 exp – 12
– Receiver input wavelength range: 1290 to 1605 nm or 850nm
• Dimensions
– Height: 12.650 in. (321.3 mm)
Table A-33 MXP_MR_2.5G/MXPP_MR_2.5G Card Receiver Trunk Side Specifications
OSNR
1
1. OSNR defined with 0.1 nm RBW
FEC Type Pre-FEC BER Post-FEC BER
Input Power
Sensitivity
Chromatic Dispersion
Tolerance
17 dB N/A < 10 exp – 12 N/A – 9 to – 23 dBm —
17 dB N/A < 10 exp – 12 N/A – 9 to – 22 dBm +/– 1800 ps/nm
17 dB N/A < 10 exp – 12 N/A – 9 to – 21 dBm +/– 5400 ps/nm
18 dB N/A < 10 exp – 12 N/A – 9 to – 23 dBm +/– 1800 ps/nm
19 dB N/A < 10 exp – 12 N/A – 9 to – 23 dBm +/– 5400 ps/nm
21 dB N/A < 10 exp – 12 N/A – 9 to – 30 dBm —
21 dB N/A < 10 exp – 12 N/A – 9 to – 29 dBm +/– 1800 ps/nm
21 dB N/A < 10 exp – 12 N/A – 9 to – 28 dBm +/– 5400 ps/nm
22 dB N/A < 10 exp – 12 N/A – 9 to – 30 dBm +/– 1800 ps/nm
23 dB N/A < 10 exp – 12 N/A – 9 to – 30 dBm +/– 5400 ps/nm