Cisco ONS 15454 DWDM - A.5.4 OPT-BST-L Amplifier Card Specifications

A-16
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Appendix A Hardware Specifications
A.5.4 OPT-BST-L Amplifier Card Specifications
– Maximum output power (with full channel load): 20 dB
– Minimum output power (with one channel): –0 dBm
– Input power (Pin) range at full channel load: –6 to 12 dBm
– Input power (Pin) range at single channel load: –26 to –8 dBm
– Noise figure at G
3
23 dB = 6 dB
– OSC filter drop (channels) insertion loss maximum: 1 dB
– OSC filter drop (OSC) insertion loss maximum: 1.8 dB
– OSC filter add (OSC) insertion loss maximum: 1.3 dB
– Optical connectors: LC-UPC/2
• Dimensions
– Height: 12.65 in. (332 mm)
– Width: 0.921 in. (23.4 mm) (The dimension of the finger gasket is not included)
– Depth: 9.00 in. (240 mm)
A.5.4 OPT-BST-L Amplifier Card Specifications
The OPT-BST-L amplifier card has the following specifications:
• Optical characteristics:
– Total operating wavelength range: 1570.0 to 1605.0 nm
– Gain ripple (peak to valley): 1.5 dB
– Gain range: 8 to 20 dB with programmable gain tilt
– Extended gain range: 20 to 27 dB with gain tilt uncontrolled
– Gain and power regulation over/undershoot: 0.5 dB
– Limited maximum output power: 10 dBm
– Maximum output power (with full channel load): 17 dB
– Minimum output power (with one channel): –1 dBm
– Input power (Pin) range at full channel load: –10 to 9 dBm
– Input power (Pin) range at single channel load: –37 to –18 dBm
– Noise figure at G
3
20 dB = 7.5 dB
– Insertion loss (Line RX to OSC TX): 0.3 to 1.8 dB
– Insertion loss (Line RX to COM TX): 0.3 to 1.0 dB
– Insertion loss (OSC RX to LINE TX): 0.3 to 1.3 dB
– Optical connectors: LC-UPC/2
• Dimensions
– Height: 12.65 in. (332 mm)
– Width: 0.921 in. (23.4 mm) (The dimension of the finger gasket is not included)
– Depth: 9.00 in. (240 mm)