Cisco ONS 15454 DWDM - A.3.5 MIC-A;P FMEC Specifications (ETSI Only)

A-11
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Appendix A Hardware Specifications
A.3.5 MIC-A/P FMEC Specifications (ETSI only)
• Environmental
– Overvoltage protection: as in ITU-T G.703 Annex B
• Dimensions of AEP board
– Height: 20 mm (0.79 in.)
– Width: 330 mm (13.0 in.)
– Depth: 89 mm (3.5 in.)
– Weight: 0.18 kg (0.4 lb)
A.3.5 MIC-A/P FMEC Specifications (ETSI only)
The MIC-A/P FMEC card has the following specifications:
• Power supply input BATTERY B
– System supply voltage: Nominal –48 VDC
Tolerance limits: –40.5 to –57.0 VDC
– Connector: 3WK3 Combo-D power cable connector
• Alarm outputs
– Voltage (open contact): Maximum 60 VDC
– Current (closed contact): Maximum 250 mA
– Connector: 62-pin DB connector (common for inputs/outputs)
• Alarm inputs
– Voltage (open contact): Maximum 60 VDC
– Current (closed contact): Maximum 2 mA
– Connector: 62-pin DB connector (common for inputs/outputs)
• Dimensions
– Height: 182 mm (7.165 in.)
– Width: 31.88 mm (1.255 in.)
– Depth: 92 mm (3.62 in.)
– Depth with backplane connector: 98 mm (3.87 in.)
– Weight not including clam shell: 0.2 kg (0.5 lb)
A.3.6 MIC-C/T/P FMEC Specifications (ETSI only)
The MIC-C/T/P FMEC card has the following specifications:
• Power supply input BATTERY A
– System supply voltage: Nominal –48 VDC
Tolerance limits: –40.5 to –57.0 VDC
– Connector: 3WK3 Combo-D power cable connector
• Timing connector
– Frequency: 2.048 MHz +/–10 ppm