Cisco ONS 15454 DWDM - A.3.7 MS-ISC-100 T Card Specifications

A-12
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Appendix A Hardware Specifications
A.3.7 MS-ISC-100T Card Specifications
– Signal level: 0.75 to 1.5 V
– Impedance: 75 ohms +/–5 percent (switchable by jumper to high impedance > 3 kohms)
Note 120 ohms balanced impedance is possible with external matching cable.
– Cable attenuation: Up to 6 dB at 2 MHz
– Connectors: 1.0/2.3 miniature coax connector
• System management serial port:
– System management serial port craft interface
– Modem port (for future use)
– Connectors: 8-pin RJ-45
• System management LAN port connectors:
– Signal: IEEE 802.3 10BaseT
– Connectors: 8-pin RJ-45
• Dimensions
– Height: 182 mm (7.165 in.)
– Width: 31.88 mm (1.255 in.)
– Depth: 92 mm (3.62 in.)
– Depth with backplane connector: 98 mm (3.87 in.)
– Weight not including clam shell: 0.2 kg (0.5 lb)
A.3.7 MS-ISC-100T Card Specifications
The MS-ISC-100T card has the following specifications:
• Dimensions
– Height: 12.650 in. (321.3 mm)
– Width: 0.921 in. (23.4 mm) (The dimension of the finger gasket is not included)
– Depth: 9.000 in. (228.6 mm)
– Depth with backplane connector: 9.250 in. (235 mm)
– Weight not including clam shell: 2.3 lb (1.0 kg)
A.4 Optical Service Channel Cards
This section provides specifications for the OSCM and OSC-CSM cards.