Cisco ONS 15454 DWDM - Table 18-8 Supported ONS 15454 Snmpv2 Trap Variable Bindings

18-11
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Chapter 18 SNMP
18.7.2 Variable Trap Bindings
Table 18-8 Supported ONS 15454 SNMPv2 Trap Variable Bindings
Group
Trap Name(s) Associated
with
Variable
Binding
Number SNMPv2 Variable Bindings Description
A dsx1LineStatusChange
(from RFC 2495)
(1) dsx1LineStatus This variable indicates the line
status of the interface. It contains
loopback, failure, received alarm
and transmitted alarm
information.
(2) dsx1LineStatusLastChange The value of MIB II’s sysUpTime
object at the time this DS1
entered its current line status
state. If the current state was
entered prior to the last
proxy-agent reinitialization, the
value of this object is zero.
(3) cerent454NodeTime The time that an event occurred.
(4) cerent454AlarmState The alarm severity and
service-affecting status.
Severities are Minor, Major, and
Critical. Service-affecting
statuses are Service-Affecting
and Non-Service Affecting.
(5) snmpTrapAddress The address of the SNMP trap.
B dsx3LineStatusChange
(from RFC 2496)
(1) dsx3LineStatus This variable indicates the line
status of the interface. It contains
loopback state information and
failure state information.
(2) dsx3LineStatusLastChange The value of MIB II's sysUpTime
object at the time this DS3/E3
entered its current line status
state. If the current state was
entered prior to the last
reinitialization of the
proxy-agent, then the value is
zero.
(3) cerent454NodeTime The time that an event occurred.
B
(cont.)
(4) cerent454AlarmState The alarm severity and
service-affecting status.
Severities are Minor, Major, and
Critical. Service-affecting
statuses are Service-Affecting
and Non-Service Affecting.
(5) snmpTrapAddress The address of the SNMP trap.