Cisco ONS 15454 DWDM - B.1 Service States

B-1
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
APPENDIX
B
Administrative and Service States
This appendix describes the administrative and service states for Cisco ONS 15454 dense wavelength
division multiplexing (DWDM) cards, optical payload ports, out-of-band optical service channel (OSC)
ports, optical channel network connections (OCHNCs), and transponder/muxponder cards and ports.
States for Software Release 5.0 and later are based on the generic state model defined in
Telcordia GR-1093-Core, Issue 2 and ITU-T X.731.
B.1 Service States
Service states include a Primary State (PST), a Primary State Qualifier (PSTQ), and one or more
Secondary States (SST). Table B-1 lists the ANSI and ETSI service state PSTs and PSTQs supported by
the ONS 15454.
Table B-2 defines the ANSI and ETSI SSTs supported by the ONS 15454.
Table B-1 ONS 15454 Service State Primary States and Primary State Qualifiers
ANSI Primary State, Primary
State Qualifier
ETSI Primary State, Primary
State Qualifier Definition
IS-NR (In-Service and Normal) Unlocked-enabled The entity is fully operational and will perform as
provisioned.
OOS-AU (Out-of-Service and
Autonomous)
Unlocked-disabled The entity is not operational because of an autonomous
event.
OOS-AUMA (Out-of-Service
and Autonomous Management)
Locked-disabled The entity is not operational because of an autonomous
event and has also been manually removed from service.
OOS-MA (Out-of-Service and
Management)
Locked-enabled The entity has been manually removed from service.