Cisco ONS 15454 DWDM - A.9.9 MXP_MR_10 DME_L Card Specifications

A-68
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Appendix A Hardware Specifications
A.9.9 MXP_MR_10DME_L Card Specifications
A.9.9 MXP_MR_10DME_L Card Specifications
The MXP_MR_10DME_L card has the following specifications:
• Payload configuration
– FC1G—Fibre Channel 1.06 Gbps
– FC2G—Fibre Channel 2.125 Gbps
– FC4G—Fibre Channel 4.25 Gbps
– FICON1G—Fiber connectivity 1.06 Gbps (IBM signal)
– FICON2G—Fiber connectivity 2.125 Gbps (IBM signal)
– FICON4G—Fiber connectivity 4.25 Gbps (IBM signal)
– ISC compatability
– ISC peer 1G
– ISC peer 2G
– ONE_GE—One Gigabit Ethernet 1.125 Gbps
– Mixed configurations up to maximum line rate of 10.0 Gbps. See the
“8.10 MXP_MR_10DME_C and MXP_MR_10DME_L Cards” section on page 8-51 for more
information on mixed-mode operation.
• Client ports: 8x SFP
• Line (trunk side)
– Bit rate: 9.952 Gbps for OC-192/STM-64
– Code: Scrambled NRZ
– Fiber: 1550-nm single-mode
– Loopback modes: Terminal and facility
Caution You must use a 20-dB fiber attenuator (15 to 25 dB) when working with the
MXP_MR_10DME_L card in a loopback on the trunk port. Do not use direct fiber loopbacks
with the MXP_MR_10DME_L cards. Using direct fiber loopbacks causes irreparable damage
to the MXP_MR_10DME_L cards.
– Connectors: LC
• Transmitter (trunk side)
– Minimum output power: +3 dBm
– Maximum output power: +6 dBm
– Minimum SMSR: 30 dB
– Minimum optical extinction ratio: 10.5 dB
– 40 wavelength tunability at 100-GHz spacing, 80 wavelength tunability at 50-GHz spacing
– Receiver maximum return reflectance (Rx return loss): –27 dB
– Chromatic dispersion allowance: 5400 ps/nm, giving an optical power penalty < 2.0 dB
– Minimum side mode suppression ratio: 30 dB
– Wavelength stability (drift): +/– 25 picometers (pm)