Cisco ONS 15454 SDH - Page 20

Figures
iv
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Figure 6-7 Setting Attributes for a Low-Order Tunnel 6-44
Figure 6-8 Setting Attributes for a Low-Order Aggregation Point 6-51
Figure 6-9 Setting Circuit Attributes for an High-Order Circuit 6-57
Figure 6-10 Two Port Bidirectional Transponder Mode 6-93
Figure 6-11 One Port Bidirectional Transponder Mode 6-94
Figure 6-12 Two-Port Unidirectional Transponder Mode 6-95
Figure 6-13 Setting VCAT Circuit Attributes 6-99
Figure 6-14 Automatically Routing a VCAT Circuit 6-99
Figure 7-1 VC4 Monitor Circuit Received at an STM-1 Port 7-6
Figure 8-1 Viewing Performance Monitoring Information 8-3
Figure 9-1 Select Affected Circuits Option 9-4
Figure 9-2 Shelf LCD Panel 9-5
Figure 9-3 Provisioning External Alarms on the AIC-I Card 9-9
Figure 12-1 Span Upgrade Shortcut Menu 12-9
Figure 12-2 Span Upgrade Wizard 12-10
Figure 13-1 Selecting Protection Group Ports 13-3
Figure 13-2 Refibering the Protect Path 13-3
Figure 13-3 Linear ADM to MS-SPRing Conversion 13-9
Figure 14-1 Three-Node, Two-Fiber MS-SPRing Before a Fourth Node Is Added 14-3
Figure 14-2 Three-Node, Four-Fiber MS-SPRing Before a Fourth Node is Added 14-4
Figure 14-3 Four-Node, Two-Fiber MS-SPRing Before a Node Is Removed 14-8
Figure 14-4 Selecting Protection Group Ports 14-17
Figure 14-5 Refibering the Protect Path 14-17
Figure 15-1 Reusable Fan-Tray Air Filter in an External Filter Bracket (Front Door Removed) 15-3
Figure 15-2 Restoring the TCC2/TCC2P Database 15-7
Figure 15-3 Restoring the Database—In-Process Notification 15-8
Figure 15-4 Viewing the Audit Trail Records 15-11
Figure 15-5 Removing or Replacing the Fan-Tray Assembly (Front Door Removed) 15-24
Figure 17-1 Mounting an ONS 15454 SDH in a Rack 17-5
Figure 17-2 Three-Shelf ONS 15454 SDH Bay Assembly 17-8
Figure 17-3 Mounting the Air Ramp in a Rack 17-9
Figure 17-4 Removing the ONS 15454 SDH Front Door 17-11
Figure 17-5 Grounding the ONS 15454 SDH 17-14
Figure 17-6 Installing Fiber-Optic Cables 17-18
Figure 17-7 Manually Routing a VCAT Circuit 17-21