17-43
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D52 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Automatic Host Detection
h. In the IP Address field, enter any legitimate IP address other than the node IP address.
Note You can suppress the LCD IP address display using CTC. For more information, see the
“DLP-D60 Log into CTC” task on page 17-49 for the default IP address.
i. In the Subnet Mask field, type the same subnet mask as the ONS 15454 SDH. The default is
255.255.255.0 (24 bit).
j. Click OK.
k. In the TCP/IP dialog box, click the Gateway tab.
l. In the New Gateway field, type the address entered in Step h. Click Add.
m. Verify that the IP address appears in the Installed Gateways field, then click OK.
n. When the prompt to restart your PC appears, click Ye s .
Step 4 If you have Windows NT 4.0 installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Settings > Control Panel.
b. In the Control Panel dialog box, click the Network icon.
c. In the Network dialog box click the Protocols tab, choose TCP/IP Protocol, then click Properties.
d. Click the IP Address tab.
e. In the IP Address window, click Specify an IP address.
f. In the IP Address field, enter any legitimate IP address other than the node IP address.
Note You can suppress the LCD IP address display using CTC. For more information, see the
“DLP-D60 Log into CTC” task on page 17-49 for the default IP address.
g. In the Subnet Mask field, type the same subnet mask as the ONS 15454 SDH. The default is
255.255.255.0 (24 bit).
h. Click Advanced.
i. In the Gateways List, click Add. The TCP/IP Gateway Address dialog box appears.
j. Type the IP address entered in Step f in the Gateway Address field.
k. Click Add.
l. Click OK.
m. Click Apply.
n. Reboot your PC.
Step 5 If you have Windows 2000 installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Settings > Network and Dial-up Connections >
Local Area Connection.
b. In the Local Area Connection Status dialog box, click Properties.
c. In the General tab, choose Internet Protocol (TCP/IP), then click Properties.
d. Click Use the following IP address.
To Next Page
Loading...
