17-44
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D52 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Automatic Host Detection
e. In the IP Address field, enter any legitimate IP address other than the node IP address.
Note You can suppress the LCD IP address display using CTC. For more information, see the
“DLP-D60 Log into CTC” task on page 17-49 for the default IP address.
f. In the Subnet Mask field, type the same subnet mask as the ONS 15454 SDH. The default is
255.255.255.0 (24 bit).
g. Type the IP address entered in Step e in the Gateway Address field.
h. Click OK.
i. In the Local Area Connection Properties dialog box, click OK.
j. In the Local Area Connection Status dialog box, click Close.
Step 6 If you have Windows XP installed on your PC, complete the following steps:
a. From the Windows Start menu, choose Control Panel > Network Connections.
Note If the Network Connections menu is not available, click Switch to Classic View.
b. From the Network Connections dialog box, click the Local Area Connection icon.
c. From the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then
click Properties.
d. In the IP Address field, enter any legitimate IP address other than the node IP address.
Note You can suppress the LCD IP address display using CTC. For more information, see the
“DLP-D60 Log into CTC” task on page 17-49 for the default IP address.
e. In the Subnet Mask field, type the same subnet mask as the ONS 15454 SDH. The default is
255.255.255.0 (24 bit).
f. Type the IP address entered in Step d in the Gateway Address field.
g. Click OK.
h. In the Local Area Connection Properties dialog box, click OK.
i. In the Local Area Connection Status dialog box, click Close.
Step 7 Return to your originating procedure (NTP).
To Next Page
Loading...
