IN-1
Cisco ONS 15454 SDH Procedure Guide, R6.0
78-17194-01
INDEX
Numerics
1+1 optical card protection
description 4-11
creating 17-64
creating a half circuit 6-68
deleting 18-47
modifying 18-46
provisioning half circuits 20-5, 20-6
testing 17-81
upgrading optical speeds 12-7, 19-81
verifying active/standby status for a port 18-77
1:1 electrical card protection
converting cards to 1:N protection 18-63, 18-65
creating 17-62
deleting 18-47
description 4-11
modifying 18-42
1:N electrical card protection
converting cards from 1:1 protection 18-63, 18-65
creating 17-63
deleting 18-47
description 4-11
modifying 18-44
15454_MRC-12 card. See MRC-12 cards
A
acceptance test
four-fiber MS-SPRing 5-16
linear ADM network 5-8
open-ended SNCP 5-36
point-to-point network turn-up 5-4
SNCP 5-24
two-fiber MS-SPRing 5-14
active logins
terminating 18-7
viewing 18-7
add/drop multiplexer. See linear ADM
adding
member to a VCAT circuit 17-67
MS-SPRing node 14-2
node to a circuit A-11
node to a domain 18-42
node to a linear ADM 14-14, 14-15
node to current session or login group 17-53
node using the toolbar A-5
SNCP node 14-10
static TIC-to-NSAP entry to the TDC 18-57
TARP manual adjacency table entry 18-58
ADM. See linear ADM
AIC-I card
changing external alarms 19-5
changing external controls 19-6
changing orderwire settings 19-7
installing 20-26
modifying settings 10-3
provisioning external alarms and controls 9-8
air filter
inspecting 15-2
replacing 15-2
requirement 1-11
alarm profiles
assigning to cards and nodes 18-18
assigning to ports 21-9
creating 21-6
To Next Page
Loading...
