-SCS Parameter Analyzer Reference Manual Section 9: Keithley External Control Interface (KXCI)
4200A-901-01 Rev. C / February 2017 9-11
DE page command strings
The DE page command strings include:
• CH: SMU channel definition (on page 9-14)
• VS: VS1...VSn channel definition (on page 9-15)
• VM: VM1...VMn channel definition (on page 9-16)
SS page command strings
The SS page command strings include:
• VR and IR: VAR1 setup (on page 9-17)
• VP and IP: VAR2 setup (on page 9-20)
• ST command: Auto standby (on page 9-22)
• FS command: VAR1' setup (on page 9-23)
• RT command: VAR1' setup (on page 9-24)
• VL and IL commands: List sweep setup (on page 9-25)
• VC and IC commands: SMU constant voltage or current setup (on page 9-26)
• SC command: Constant VS setup (on page 9-27)
• HT command: Set sweep hold time (on page 9-27)
• DT command: Set sweep delay time (on page 9-28)
SM page command strings
The measurement setup (SM) page command strings include:
• WT command: Set wait time (on page 9-29)
• IN command: Set interval (on page 9-29)
• NR command: Select number of readings (on page 9-30)
• DM command: Select display mode (on page 9-30)
• LI command: List mode, enables V and I functions for test sequence (on page 9-31)
• XN command: Configure graph X-axis for electrical parameter (on page 9-32)
• XT command: Configure graph X-axis for time domain (on page 9-32)
• YA command: Configure graph Y1 axis (on page 9-33)
• YB command: Configure graph Y2 axis (on page 9-34)
MD page command strings
The measurement control (MD) page command string includes:
• ME command: Control measurements (on page 9-35)
To Next Page
Loading...
