Rockwell Automation Publication 2198-UM004D-EN-P - December 2022 143
Chapter 7 Configure the Drive with KNX5100C Software
4. Click Accept if you want to use those values, or click Cancel if you want to
stay with the parameters that you added manually.
Dynamic Motor Analyzer - Induction Motors
The dynamic motor test generates motion, be sure your motor is un-coupled to
perform this test. To use the motor analyzer feature for induction motors,
perform the following steps.
1. Select Motor > Analyzer.
2. Select Dynamic Analysis and click Start to initiate the analysis.
3. After each step of the analyzing process is completed, a confirmation
window appears; click OK.
A results window appears with suggested parameter values.
4. Click Accept if you want to use those values, or click Cancel if you want to
stay with the parameters that you added manually.
To Next Page
Loading...
