Cisco ONS 15454 DWDM Reference Manual

FIGURES
xxvii
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Figure 1-1 Cisco ONS 15454 ANSI Shelf Dimensions 1-4
Figure 1-2 Mounting an ONS 15454 ANSI Shelf in a Rack 1-5
Figure 1-3 ONS 15454 ETSI Shelf Assembly Dimensions 1-7
Figure 1-4 Mounting an ONS 15454 ETSI Shelf in a Rack 1-8
Figure 1-5 Three-Shelf ONS 15454 ETSI Bay Assembly 1-9
Figure 1-6 Two-Channel Add/Drop FlexLayer Module Block Diagram 1-11
Figure 1-7 ONS 15454 Two-Channel Optical Add/Drop FlexLayer Module 1-12
Figure 1-8 Two-Channel Drop Component Connector Mapping and Labeling 1-12
Figure 1-9 Two-Channel Add Component Connector Mapping and Labeling 1-13
Figure 1-10 Typical Y-Cable Protection Module Configuration 1-14
Figure 1-11 1:2 Splitter and 2:1 Coupler (Y-Cable Protection) Module Block Diagram 1-15
Figure 1-12 ONS 15454 Y-Cable Protection FlexLayer Module (Single-Mode) 1-15
Figure 1-13 ONS 15454 Y-Cable Protection FlexLayer Module (Multimode) 1-16
Figure 1-14 Y-Cable Protection Component Connector Mapping and Labeling 1-16
Figure 1-15 Y-Cable Protection Module Tray 1-18
Figure 1-16 Y-Cable Protection Port Label 1-19
Figure 1-17 Typical DWDM Equipment Layout in an ONS 15454 ANSI Rack 1-20
Figure 1-18 The ONS 15454 Front Door 1-21
Figure 1-19 Cisco ONS 15454 ANSI Deep Door 1-22
Figure 1-20 ONS 15454 ANSI Front Door Ground Strap 1-23
Figure 1-21 Removing the ONS 15454 ANSI Front Door 1-24
Figure 1-22 Removing the ONS 15454 ETSI Front Door 1-25
Figure 1-23 ONS 15454 ANSI Front-Door Erasable Label 1-26
Figure 1-24 ONS 15454 ETSI Front-Door Erasable Label 1-27
Figure 1-25 Laser Warning on the ONS 15454 ANSI Front-Door Label 1-27
Figure 1-26 Laser Warning on the ONS 15454 ETSI Front-Door Label 1-28
Figure 1-27 Backplane Covers 1-29
Figure 1-28 Removing the Lower Backplane Cover 1-29
Figure 1-29 Backplane Attachment for Cover 1-30
Figure 1-30 Installing the Plastic Rear Cover with Spacers 1-31

Cisco ONS 15454 DWDM Specifications

General

Chassis Type	DWDM
Form Factor	Rack-mountable
Slots	17
Storage Temperature	-40 to 158°F (-40 to 70°C)
Relative Humidity	5% to 95% non-condensing
Power Supply	AC or DC
Cooling	Internal fans
Operating Temperature	23 to 104°F (-5 to 40°C)
Altitude	0 to 6500 ft (0 to 1981 m)
Safety Compliance	EN 60950-1
EMI Compliance	FCC Part 15