9-60
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Chapter 9 Node Reference
9.6 Automatic Node Setup
–
Provisioned—The value was manually provisioned.
• Note—Displays information for parameters that could not be calculated, that is, parameters with
Unknown appearing in the Value column.
Table 9-11 shows the following information displayed for ANS parameters on the Provisioning >
WDM-ANS > Provisioning tab.
• Side—The optical side, which can be A (Slots 1 through 6) or B (Slots 12 through 17) for DWDM
nodes in non-mesh DWDM networks, or A, B, C, D, E, F, G, or H for nodes in DWDM mesh
networks.
• Rx/Tx—Indicates whether the parameter is transmit or receive.
• Category—The parameter category as displayed in the ANS parameter tree.
• Min—Minimum value in decibels.
• Max—Maximum value in decibels.
• Def—Default value in decibels. Other defaults include MC (metro core), CG (control gain),
U (unknown).
• Optical Type—Parameter optical type: T (Terminal), FC (flexible channel count terminal),
O (OADM), H (hub), L (line amplifier), R (ROADM), or U (unknown).
To Next Page
Loading...
