liv
Cisco ONS 15454 DWDM Reference Manual, R8.5
78-18343-02
Preface
November 2010 • Updated the section, “SNMP in Multishelf Management” in the chapter,
SNMP.
• Updated the width of the single slot cards for Control cards and
Transponder and Muxponder Cards in the appendix, "Hardware
Specifications".
• Updated the table “SFP/XFP Card Compatibility” in the chapter
“Transponder and Muxponder Cards”.
• Updated the tables “SFP Specifications” and “Single-Mode Fiber SFP Port
Cabling Specifications” in the appendix, “Hardware Specifications”.
January 2011
• Updated the width of all the cards in the appendix, "Hardware
Specifications".
April 2011
• Updated the "Key Features" section for ADM-10G card in the chapter
"Transponder and Muxponder Cards".
• Updated the power values in the “Individual Card Power Requirements”
table in the appendix, “Hardware Specifications”.
May 2011
• Updated the section “SFP and XFP Modules” in the chapter “Transponder
and Muxponder Cards”.
• Removed the sections “SFP Specifications” and “XFP Specifications” and
added the section “SFP and XFP Specifications” in the appendix
“Hardware Specifications”.
June 2011 Updated the section “AIC-I Card” in the chapter “Common Control Cards”.
July 2011
• Added a note in the “PC and UNIX Workstation Requirements” section of
Chapter, “Cisco Transport Controller Operation”.
September 2011
• Updated the key features section of TXP_MR_10G, TXP_MR_10E,
TXP_MR_10E_C, and TXP_MR_10E_L cards in the chapter
“Transponder and Muxponder Cards”.
• Added a note to SONET PM Parameters table in “SONET PM Parameter
Definitions” section.
• Replaced G.975.1 with G.975.1 I.7 and added a note in the chapter,
“Transponder and Muxponder Cards”.
• Created a “Summary Pane” section in the chapter, “Cisco Transport
Controller Operation”.
October 2011
• Removed the Temperature table and updated the Temperature section with
standard operating temperature values and removed the Environmental
section from all the 15454 card specifications in the appendix "Hardware
Specifications."
• Updated the figure “Scenario 3: Using Proxy ARP with Static Routing
(ANSI and ETSI)” in the chapter “Management Network Connectivity”.
December 2011
• Updated the power values in the table “Individual Card Power
Requirements” in the appendix “Hardware Specifications”.
• Updated the section “Termination Modes” in the chapter “Transponder and
Muxponder Cards”.
Date Notes
To Next Page
Loading...
Need help?
General
