Procedures
vi
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP-D283 Create an Automatically Routed VCAT Circuit 6-97
NTP-D284 Create a Manually Routed VCAT Circuit 6-101
NTP-D325 Create an STM Test Circuit around the Ring 6-103
NTP-D350 Create a Server Trail 6-106
Manage Circuits 7-1
NTP-D199 Locate and View Circuits 7-2
NTP-D200 View Cross-Connect Card Resource Usage 7-2
NTP-D287 Modify and Delete Circuits 7-4
NTP-D288 Modify and Delete Overhead Circuits and Server Trails 7-4
NTP-D78 Create a Monitor Circuit 7-5
NTP-D329 Create a J0 Section Trace 7-6
NTP-D79 Create a J1 or J2 Path Trace 7-8
NTP-D332 Bridge and Roll Traffic 7-9
NTP-D309 Reconfigure Circuits 7-10
NTP-D310 Merge Circuits 7-11
NTP-D352 Manage VLANs 7-11
Monitor Performance 8-1
NTP-D257 Change the PM Display 8-2
NTP-D195 Monitor Electrical Performance 8-3
NTP-D198 Monitor Ethernet Performance 8-4
NTP-D289 Create and Delete Ethernet RMON Thresholds 8-5
NTP-D254 Monitor STM-N Performance 8-5
NTP-D301 Monitor FC_MR-4 Performance 8-6
NTP-D302 Create or Delete FC_MR-4 RMON Thresholds 8-6
Manage Alarms 9-1
NTP-D195 Document Existing Provisioning 9-2
NTP-D196 View Alarms, History, Events, and Conditions 9-2
NTP-D68 Delete Cleared Alarms from Display 9-3
NTP-D69 View Alarm-Affected Circuits 9-4
NTP-D70 View Alarm Counts on the LCD for a Node, Slot, or Port 9-5
NTP-D71 Create, Download, and Assign Alarm Severity Profiles 9-6
NTP-D168 Enable, Modify, or Disable Alarm Severity Filtering 9-7
NTP-D72 Suppress Alarms or Discontinue Alarm Suppression 9-7
NTP-D247 Provision External Alarms and Controls on the Alarm Interface Controller–International 9-8
To Next Page
Loading...
