Cisco ONS 15454 SDH - Page 842

Index
IN-10
Cisco ONS 15454 SDH Procedure Guide, R6.0
78-17194-01
refreshing PM counts at a different time
interval 21-40
resetting 15-16, 17-30
routing fiber on 2-19
threshold variables (MIBs) 21-41, 21-42
viewing PM parameters 21-37, 21-38, 21-39
ferrites 1-18
fiber
See also cables
attaching to GBICs 20-28
attaching to STM-N cards 17-17
cleaning connectors 15-15
installing on STM-N cards 2-16
installing the fiber boot 17-35
reversible fiber guides 2-20
routing cables 2-19
fiber boot, installing 17-35
fiber clips 2-19, 18-3
fiber connections
attach to LGX interface 17-33
linear configuration 17-17
MS-SPRing 20-37
SNCP 20-33
SNCP DRI 20-35
subtending a MS-SPRing from an SNCP 5-40
subtending an SNCP from an MS-SPRing 5-39
verifying SNCP 5-23
filler card, install 2-14
filtering
alarms 19-24
alarms by severity 9-7
circuit display 19-65
disabling for alarms 19-25
link classes on the network map A-8
modifying parameters 21-12
finding
alarms and conditions on the network 19-83
circuits 18-26
firewalls, setting up access 4-8
firewall tunnels
deleting 18-1
provisioning 17-83
flow control watermark provisioning 20-58
FMEC
attaching electrical cables 1-16
installing cables 20-18, 20-20
installing power and signal FMECs 1-7
installing the FMEC cover 1-17
opening the cover 20-10
removing the cover 20-11
Force switch
See also external switching commands
clearing SNCP 18-85
initiating 18-84
foreign node setting
changing DCC 20-65
changing MS-DCC 20-65
enable using RS-DCC 20-68
enabling using MS-DCC 20-71
provisioning MS-DCC 20-71
specifying IP address 20-65, 20-66
front door
opening 1-6, 17-9
removing 1-6, 15-3, 17-10
replacing 2-21
G
G1K-4 card. See G-Series Ethernet cards
gateway network element 18-43
gateway settings, provisioning 19-53
GBICs
installing 20-28
removing 20-32
routing fiber on 2-19
gigabit interface converter. See GBIC
ground
connecting 17-13