Adding effects |151
Including or excluding the dry (direct) signal
The dry (or ‘direct’) signal is the raw sound, without the effects. It should
be normally included in the output signal to give a sense or presence of the
source Sound.
1 Go to the Mixer/Tuning > Volume/Pan page.
2 Select or deselect the Dry checkbox corresponding to the Sound you want
to program.
Dry Meaning
On The direct signal is sent to the output, mixed with FXs.
Track
Off The direct signal is removed from the audio output, and only sent
to the FXs. The effected signal will still be positioned (in stereo FXs
only) according to the Pan value.
Track
To Next Page
Loading...
Need help?
General
