Mono-Mono Serial (Mono-Mono) |575
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
104: Decimator - Amp (Decimator - Amp Simulation)
This effect combines a mono decimator and an amp simulation. You can
change the order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Decimator
Routing
Amp Simulation
Amp Simulation Filter
Pre LPF
High Damp
Output Level
Decimator
Resolution
DECIMATOR
a [D]Pre LPF Off, On Turn the harmonic noise caused
by lowered sampling on and off
High Damp [%] 0…10 0 Sets the ratio of high-range damp-
ing
b [D]Sampling Freq [Hz] 1.00k…48.00k Sets the sampling frequency
Resolution 4…24 Sets the data bit length
c [D]Output Level 0…10 0 Sets the decimator output level
AMP SIM
d [A]Amplier Type SS, EL84, 6L6 Selects the type of guitar amplier
e Routing
Decimator › Amp,
Amp › Decimator
Switches the order of the decima-
tor and amp simulation
f Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source