334| Editing the Sounds
Setting the velocity switch between the Low and High layers
▪ Use the Vel SW L–>H parameter to set the velocity value dividing the High
and Low multisamples for the selected oscillator. Notes struck harder than
this value will be played by the High multisample.
Choosing an AMS (Alternate Modulation Source)
When the AMS option is assigned to the Offset parameter, the Offset
Intensity by AMS and AMS parameters become available. A list of AMS
sources can be found in the Appendix.
1 When the Offset Intensity by AMS parameter has a positive value, the se-
lected Offset point will depend by the AMS value. For example, with the
Velocity AMS, playing softly will select the Off or 1st Offset, while playing
loudly will select the 6th or No Attack Offset.
When the Offset Intensity by AMS parameter has a negative value, the se-
lection will happen in reverse (higher-numbered Offsets will be selected be-
fore the lowest-numbered ones).
Oscillator triggering
Triggering Mode is how the oscillator will start when pressing a key.
Choosing the oscillator triggering mode
▪ Use the OSC Trigger Mode > Mode pop-up menu to choose how to trigger
the selected oscillator. For example, a Normal-triggered oscillator will always
play, while a Legato-triggered oscillator will only play when a note is played
legato.
Trigger Mode Meaning
Normal The Oscillator always plays when a key is pressed (unless the
“OSC Off when Sound Controllers are On” parameter is checked).
Legato The Oscillator only plays when the note is played ‘legato’. The de-
lay and pitch interval from the previous note are also to be con-
sidered, as set in the Sound Edit > Basic > Sound Basic page
(Legato as OSC Trigger parameter).
Staccato The Oscillator only plays when the note is NOT played legato (it is
the opposite of the above choice).
To Next Page
Loading...
Need help?
General
