594| Effects for the MIDI Sounds
b, c, d, e, f, g: Status
These parameters set the output status of each Tap.
Always On: Output is always on. (No modulation)
Always Off: Output is always off. (No modulation)
On/Off (dm): Output level is switched from on to off depending on the modu-
lation source.
Off/On (dm): Output level is switched from off to on depending on the modu-
lation source.
Combining these parameters, you can change from 4-phase chorus to two-
tap delay by crossfading them gradually via the modulation source during a
performance.
h: Panning Preset
This parameter selects combinations of stereo images of the tap outputs.
117: St. Pitch Shifter (Stereo Pitch Shifter)
This is a stereo pitch shifter. The pitch shift amount for the left and right
channels can be reversed from each other.
Left
Right
Feedback
Spread
FX Amt
FX Amt
Stereo In - Stereo Out
High Damp
High Damp
Input Level
Input Level
Feedback Position
Pre
Pre
Post
Post
Delay
Pitch Shifter
Delay
Pitch Shifter
a Mode Slow,
Medium, Fast
Switches Pitch Shifter mode
L/R Pitch Normal,
Up/Down
Determines whether or not the L/R pitch
shift amount is inverted
b Pitch Shift [1/2tone] –24…+24 Sets the pitch shift amount in steps of a
semitone
Src Off…Tempo Selects the modulation source of pitch
shift amount
Amt –24…+24 Sets the modulation amount of pitch shift
amount
To Next Page
Loading...
Need help?
General
