154| Advanced editing of the Sound sets
Copying the Effects
To speed up programming, you can copy a single effect (Master 1, Master 2),
or both effects of an FX group (A or B). You can copy them between differ-
ent elements (for example, between Styles and Performances, or STSs and
Songs or Sounds).
The Copy/Paste operation only copies the parameters of the Effects section.
Parameters contained in other sections, like Dry or FX Send, are not copied.
Please note that these parameters are relevant in the final sound of the ef-
fects, so please fine-tune them after copy/pasting.
Copying a single effect
1 Select the source element (Performance, STS, Style, Song or Sound).
2 Choose the source FX group (A or B) by touching the corresponding side tab.
3 Go to the edit page of the effect you want to copy (Master 1/Reverb, Master
2/Chorus).
4 Choose the Copy FX command from the page menu.
5 Select the target element (Performance, STS, Style, Song or Sound).
6 Go to the edit page of the effect you want to paste (Master 1/Reverb, Master
2/Chorus).
7 Choose the Paste FX command from the page menu.
Copying all the effects in an FX group
1 Select the source element (Performance, STS, Style, Song or Sound).
2 Go to the Effects > A/B FX Config page.
3 Choose the source FX group (A or B) by touching the corresponding side tab.
4 Choose the Copy FX command from the page menu.
5 Select the target element (Performance, STS, Style, Song or Sound).
6 Go to the Effects > A/B FX Config page.
7 Choose the target FX group (A or B) by touching the corresponding side tab.
8 Choose the Paste FX command from the page menu.
To Next Page
Loading...
Need help?
General
