EQ and Filters (EQ/Filter) |433
16: Stereo Decimator
This effect creates a rough sound like a cheap sampler by lowering the sam-
pling frequency and data bit length. You can also simulate noise unique to a
sampler (aliasing).
Left
Right
FX Amt
FX Amt
Stereo In - Stereo Out
Pre LPF
Pre LPF
High Damp Output Level
High DampOutput Level
Sampling Frequency
Decimator
Decimator
D
-mod
LFO
Resolution
Resolution
a Pre LPF Off, On Selects whether the harmonic noise
caused by a decrease in sampling fre-
quency is generated or not
High Damp [%] 0…10 0 Sets the ratio of cut of the high range
b Sampling Freq [Hz] 1.00k…
48.00k
Sets the sampling frequency
Src Of f…Tempo Selects the modulation source of the
sampling frequency
Amt –48.00k…
+48.00k
Sets the modulation amount of the sam-
pling frequency
c LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
Src Of f…Tempo Selects a modulation source for LFO
speed
Amt –20.00…
+20.00
Sets the modulation amount of LFO
speed
d MIDI Sync Off, On When this is on, the LFO speed is set
by BPM, Base Note, and Times, instead
of Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note
…
Selects the type of notes that specify
the LFO speed
Times x1…x32 Sets the number of notes that specify
the LFO speed
To Next Page
Loading...
Need help?
General
