Writing the edited Sound |393
a location as if you were choosing a Sound. Blank locations are shown as a
series of dashes (‘–––’).
4 When back at the Write Sound dialog, confirm the Write operation by touch-
ing the OK button.
Some notes about writing the Sounds
▪ If you write over an existing Sound, the Sound will be overwritten. Please
save on a storage device any User Sound you don’t want to lose.
▪ Ordinary Sounds cannot be written over Drum Kit locations. Drum Kits can-
not be written over standard Sound locations.
▪ To restore the original data, please use the Factory Restore command in the
Media > Utility page.
To Next Page
Loading...
