516| Effects for the MIDI Sounds
62: Tape Echo
This effect simulates a tape echo unit with three playback heads. The distor-
tion and tonal change typical of magnetic tape are also reproduced.
Wah Flatter
D
-mod
Tap2/3
Position
+
Tape
Saturation
Left
Right
FX Amt
Trim
PanLevel
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
Feedback
Feedback Amt
High / Low DampPre Tone
Delay
(1)
(2)
(3)
Delay Time
a Delay (Tap1) [msec] 0…2700 Sets the delay time (tap1)
Src Of f…Tempo Selects the modulation source of the de-
lay time
Amt –2700…
+2700
Sets the modulation amount of delay time
b Tap2 Position [%] 0…10 0 Sets the position of Tap 2 relative to the
Tap 1 delay time the depth of pitch varia-
tion
c Tap3 Position [%] 0…10 0 Sets the position of Tap 3 relative to the
Tap 1 delay time the depth of pitch varia-
tion
d Tap1 Level 0…10 0 Sets the Tap1 output level
Pan L, 1…99, R Sets the stereo image of tap1
FB Amt –100…+100 Sets the Tap1 feedback amount
e Tap2 Level 0…10 0 Sets the Tap2 output level
Pan L, 1…99, R Sets the stereo image of tap2
FB Amt –100…+100 Sets the Tap2 feedback amount
f Tap3 Level 0…10 0 Sets the Tap3 output level
Pan L, 1…99, R Sets the stereo image of tap3
FB Amt –100…+100 Sets the Tap3 feedback amount
g Feedback 0…10 0 Sets the amount of feedback for Taps 1,
2, and 3
Src Of f…Tempo Selects the modulation source of feed-
back amount
Amt –100…+100 Sets the feedback amount
To Next Page
Loading...
Need help?
General
