Mono-Mono Serial (Mono-Mono) |559
i [F]Output Mode Normal,
Wet Invert
Selects the output mode for the cho-
rus/anger
Routing
Limiter ›
Flanger,
Flanger ›
Limiter
Switches the order of the limiter and
chorus/anger
j Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Of f…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
92: Limiter - Phaser
This effect combines a mono limiter and a phaser. You can change the order
of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Limiter
Limiter
Gain Adjust
Envelope - Control
Phaser
Phaser
Resonance
LFO: Tri / Sine
Phaser FX Amt
Normal
Wet Invert
Output Mode
–
+
LIMITER
a [L]Ratio 1.0 : 1…
50.0 : 1, Inf : 1
Sets the signal compression ratio
Threshold [dB] –40…0 Sets the level above which the
compressor is applied
b [L]Attack 1…10 0 Sets the attack time
Release 1…10 0 Sets the release time
c [L]Gain Adjust [dB] –Inf,
–38…+24
Sets the limiter output gain
PHASER
d [P]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
To Next Page
Loading...
Need help?
General
