Setting the Sound’s basic parameters |329
Polyphony, triggering, legato
The Voice Assign Mode section is where you choose polyphony, triggering
and legato.
Choosing the mono/poly mode
▪ Use the Poly and Mono radio buttons to choose whether the Sound will play
polyphonically (playing chords) or monophonically (one voice at a time).
Choosing triggering mode
▪ When the selected mode is Poly, use the Single Trigger checkbox to choose
the triggering mode.
Single Trigger Meaning
On When the same note is played repeatedly, the previous note will
be silenced before the next note is sounded, so that the notes do
not overlap.
Off When the same note is played repeatedly, the previous note will
not be silenced before the next note is sounded.
Activating Legato
▪ When the selected mode is Mono, use the Legato checkbox to activate
Legato.
Legato will make the second note’s attack smoother. Envelope and LFO will
not be retriggered. This is particularly effective with wind instrument and
analog synth-type sounds.
To Next Page
Loading...
