EasyManuals Logo

Korg HAVIAN 30 User Manual

Korg HAVIAN 30
814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
152| Advanced editing of the Sound sets
Choosing the effects and setting their controls
Access the FX A/B Config page
1 Go to the Effects > FX A/B Config page.
2 Use the side tabs on the right to choose an FX Group.
Choose an effect for each FX processor
Use the relevant pop-up menu to choose the effect assigned to the Master
FX1 or Master FX2 processor (inside the selected FX Group).
Usually, FX1 are reverbs, while FX2 are modulating effects (chorus, flanger,
delay…). See the dedicated chapter for a list of the available effects.
Mix the direct and effected signal inside the FX processors
Use the W/D (Wet/Dry) parameter to set the balance between the Wet (ef-
fected) and Dry (direct) signal inside the corresponding FX processor.
Choose a modulating track
You can modulate one of the effect parameters by using MIDI messages gen-
erated by the internal physical controllers.
Use the M.T. (Modulating Track) parameter to choose a track as a source of
the modulating MIDI messages.

Table of Contents

Other manuals for Korg HAVIAN 30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Korg HAVIAN 30 and is the answer not in the manual?

Korg HAVIAN 30 Specifications

General IconGeneral
BrandKorg
ModelHAVIAN 30
CategoryMusical Instrument
LanguageEnglish

Related product manuals