336| Editing the Sounds
Trigger Mode Meaning
Legato Down Like Legato, but this is only activated when the second note is
out of the “Max Range” value (as set in the Basic > Sound Basic
page) and it is lower than the rst one.
Choosing a delay before note start
▪ Use the Delay parameter to set a lapse between pressing a key and hearing
the beginning of the sound.
Delay Meaning
0…5000ms Delay time (in milliseconds)
KeyOff The sound will begin when the note is released. The note velocity
is read from the Key On Velocity.
This is useful to create sounds such as the ‘click’ that is heard
when a harpsichord note is released. In this case, set the Sustain
parameter to 0 (see the Amp > Amp EG page).
KeyRel Key Release. The sound will begin when the note is released. The
note velocity is read from the Key Off Velocity.
NatRel Natural Release. The sound will begin when the note is released.
The note starts from the current volume of the sound. If the sound’s
volume is already at zero, this oscillator is not retriggered.
Reversing the controllers
▪ Select the OSC Off when Sound Controllers are On checkbox to reverse
the way Sound Controllers work. With this parameter checked, the current
oscillator will not play when one of the Sound Controllers (Sound Controller
1, Sound Controller 2, Sound Controller Y+, Sound Controller Y-) is activated.
It should be applied to oscillators with Normal, Legato, Staccato, Cycle 1,
Cycle 2, Random, After Touch Trigger On, Y+ Trigger On, Y- Trigger On,
Legato Up and Legato Down trigger modes, that can be turned off by using a
footswitch or the joystick programmed as a Sound Controller.