Mono-Mono Serial (Mono-Mono) |553
However, if a mono-input type effect is connected after this effect, the left
and right sounds may cancel each other, eliminating the chorus/flanger ef-
fects.
When “Routing” is set to Flanger/Comp, “[F]Output Mode” will be set to Nor-
mal.
88: Comp - Phaser (Compressor - Phaser)
This effect combines a mono compressor and a phaser. You can change the
order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Compressor
LEQ HEQ
EQ Trim
Comp
Output Level
Envelope - Control
Phaser
Phaser
Resonance
LFO: Tri / Sine
Phaser FX Amt
Normal
Wet Invert
Output Mode
–
+
COMPRESSOR
a [C]
Sensitivity
1…10 0 Sets the sensitivity
b [C]Attack 1…10 0 Sets the attack level
Output Level 0…10 0 Sets the compressor output level
c [C]EQ Trim 0…10 0 Sets the EQ input level
d [C]Pre LEQ Gain [dB] –15…+15 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15…+15 Sets the gain of High EQ
PHASER
e [P]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
f [P]Manual 0…10 0 Sets the frequency to which the effect
is applied
Depth 0…10 0 Sets the depth of LFO modulation
Resonance –100…+100 Sets the resonance amount
To Next Page
Loading...
Need help?
General
