Double Size |585
tion source from which the damper effect is applied. Usually, select Damper
#64 Pdl (Damper pedal).
The effect is off when a value for the modulation source specified for
the “Src” parameter is 63 or smaller, and the effect is on when the value is
64 or higher.
c: Tone
d: Mid Shape
These parameters control the tonal quality of the effect sound.
e: Tune
Since this effect simulates the resonance of the strings, the sound varies de-
pending on the pitch. If you have changed tuning using the “Master Tuning”
(Global > General Controls > Basic), adjust this parameter value.
112: OD/HyperGain Wah (Overdrive/Hyper Gain Wah)
This distortion effect has two modes: overdrive and hyper-gain that produc-
es a strong distortion. A higher high-gain setting is required for this effect
relative to a normal-size effect.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Amp Simulation
3 Band EQ
Output Level
Direct Mix
Pre Low-cut
D
-mod
Wah
Mode: Overdrive / Hyper-Gain
Drive
Driver
+
a Wah Off, On Switches Wah on/off
Src Off…Tempo Selects the modulation source
that switches the Wah on and
off
Sw Toggle, Moment Selects the switching mode
for the modulation source that
switches the Wah on and off
b Wah Sweep Range –10…+10 Sets the range of Wah
Wah Sweep Src Off…Tempo Selects the modulation source
that controls the Wah
To Next Page
Loading...
Need help?
General
