474 | Effects for the MIDI Sounds
41: 2Voice Resonator
This effect resonates the input signal at a specified pitch. You can set the
pitch, output level, and pan settings for two resonators individually. You can
control the resonance intensity via an LFO.
Left
Right
Resonance
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
High Damp
High Damp
Trim
Trim
+
Level
Level
Pan
Pan
Control Mode
D
-mod
LFO
Manual
Invert: On/Off
Resonator
Resonator
Pitch, Fine [cents]
a Control Mode Manual, LFO,
D-mod
Switches the controls of resonance intensity
LFO/D-mod
Invert
Off, On Reverses the Voice 1 and 2 control when
LFO/D-mod is selected
b LFO
Frequency
[Hz]
0.02…20.00 Sets the speed of the LFO
D-mod Src Off…Tempo Selects the modulation source that controls
resonance intensity
c MIDI Sync Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individual
effect
Base Note
…
Selects the type of notes that specify the
LFO speed
Times x1…x32 Sets the number of notes that specify the
LFO speed
d Mod. Depth –100…+100 Sets the amount of resonance intensity con-
trol via LFO/D-mod
Trim 0…10 0 Sets the input level at the resonator
e Voice1: Pitch C0…B8 Sets the voice1 Pitch for resonance
Fine [cents] –50…+50 Fine-adjusts the voice 1 pitch for resonance
Level 0…10 0 Sets the Voice1 output level