576| Effects for the MIDI Sounds
105: Decimator - Comp (Decimator - Compressor)
This effect combines a mono decimator and a compressor. You can change
the order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Decimator
Routing
Pre LPF
High Damp
Output Level
Decimator
Resolution
Compressor
Comp
Output Level
Envelope - Control
DECIMATOR
a [D]Pre LPF Off, On Turn the harmonic noise caused
by lowered sampling on and off
High Damp [%] 0…10 0 Sets the ratio of high-range
damping
b [D]Sampling Freq [Hz] 1.00k…48.00k Sets the sampling frequency
Resolution 4…24 Sets the data bit length
c [D]Output Level 0…10 0 Sets the decimator output level
COMPRESSOR
d [C]
Sensitivity
1…10 0 Sets the sensitivity
e [C]Attack 1…10 0 Sets the attack level
Output Level 0…10 0 Sets the compressor output
level
f Routing
Decimator › Comp,
Comp › Decimator
Switches the order of the deci-
mator and compressor
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and
dry signal
Src Of f…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
To Next Page
Loading...
Need help?
General
