452| Effects for the MIDI Sounds
28: St.HarmonicChorus (Stereo Harmonic Chorus)
This effect applies chorus only to higher frequencies. This can be used to
apply a chorus effect to a bass sound without making the sound thinner. You
can also use this chorus block with feedback as a flanger.
Left
Right
Feedback
LFO Phase
LFO: Tri / Sine
FX Amt
FX Amt
High Damp
Stereo In - Stereo Out
Low Level
Low Level
High Level
High Level
High/Low Split Point
High Damp
Chorus/Flanger
Chorus/Flanger
a LFO Waveform Triangle, Sine Selects the LFO Waveform
LFO Phase [de-
gree]
–180…+180 Sets the LFO phase difference between
the left and right
b LFO Frequency
[Hz]
0.02…20.00 Sets the speed of the LFO
Src Of f…Tempo Selects a modulation source for LFO
speed
Amt –20.00…+20.00 Sets the modulation amount of LFO speed
c MIDI Sync Off, On When this is on, the LFO speed is set by
BPM, Base Note, and Times, instead of
Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300
sets the tempo manually for this individual
effect
Base Note
…
Selects the type of notes that specify the
LFO speed
Times x1…x32 Sets the number of notes that specify the
LFO speed
d Pre Delay [msec] 0.0…50.0 Sets the delay time from the original sound
e Depth 0…10 0 Sets the depth of LFO modulation
Src Of f…Tempo Selects the modulation source of the LFO
modulation depth
Amt –100…+100 Sets the modulation amount of the LFO
modulation depth
f High/Low Split
Point
1…10 0 Sets the frequency split point between the
low and high range