370| Editing the Sounds
Modulating the Filter EG
Modulating the Filter EG levels
▪ Use the Level Modulation > AMS parameter to select the source that will
control the Level parameters of the filter EG.
▪ Use the Level Modulation > Intensity parameters (-99…+99) to specify the
depth and direction of the AMS. With a setting of 0, the levels specified by
the Frequency parameter will be used.
For example, if AMS is Velocity, and you set St (Start Level Swing), At (Attack
Level Swing) and Br (Break Level Swing) to + and set Intensity to a positive
(+) value, the EG levels will rise as you play more strongly. If Intensity is set to
a negative (–) value, the EG levels will fall as you play harder.
▪ Use the St (Start Level Swing), At (Attack Level Swing) and Br (Break Level
Swing) parameters to specify the direction in which AMS will affect the Start,
Attack and Break Point.
When Intensity has a positive (+) value, a setting of + for this parameter will
allow the AMS to raise the EG level, and a setting of – will allow AMS to lower
the EG level. With a setting of 0 there will be no change.
Filter 1 EG changes (level) (AMS = Velocity, Intensity = a positive (+) value)
Note-on
Note-off
Note-on
Note-off
Note-on
Note-off
Softly played note with Start
Level Swing, Attack Level Swing,
and Break Level Swing set to +
Strongly played note with Start
Level Swing, Attack Level Swing,
and Break Level Swing set to +
Strongly played note with Start
Level Swing, Attack Level Swing,
and Break Level Swing set to –
To Next Page
Loading...
Need help?
General
