Setting the Sound’s basic parameters |327
Setting the Sound’s basic parameters
Before editing the oscillators, choose the number of oscillators in the Sound,
the Sound’s mono/poly mode, and the transpose and legato ranges.
▪ Go to the Sound > Basic > Sound Basic page.
Setting the oscillators
The Oscillator Count section is where you choose how many voices will be
used by a single Sound.
Choosing the number of oscillators
▪ Use the Oscillators Count parameter to choose the number of oscillators (up
to 24) the Sound is based on.
The total polyphony varies depending on the number of oscillators used by
the Sound (a maximum of 128 with only 1 oscillator per voice).
To Next Page
Loading...
Need help?
General
