340| Editing the Sounds
Triggering notes when pressing or releasing the Damper pedal
Special effects can be achieved by triggering notes with the Damper pedal.
▪ Go to the Sound > Basic > Damper Trigger page.
The parameters in this page apply to the Sound as a whole, and not to a
single oscillator.
As warned by the message on the lower area of the display, triggered notes
must fall out of the Transpose Range programmed in the Basic > Sound Basic
page. Please either choose a note out of that range, or edit the Transpose
Range, so that the note is either higher or lower than that range.
Transpose Range
Playing a note when pressing the Damper pedal
The Damper On Trigger parameters allow to play a note when pressing the
Damper pedal (Damper On).
This is useful when a special sample is assigned to a particular note (for ex-
ample, pedal down squeaking in the Sound ‘Grand Piano RX’, breathing in the
‘Harmonica RX’ Sound …).
▪ Choose a Note, and set its Velocity.
▪ Select the Note Off on Damper Off checkbox to make the sound stop when
the Damper pedal is released.
To Next Page
Loading...
Need help?
General
