626| Auto selection and locking
Locking the Control parameters
1 Go to the Global > General Controls > Lock > Control page.
2 Select/deselect the desired locks.
Control lock Meaning
Upper 1 FXs When choosing the Upper 1 Sound, the FX settings contained
in the Sound or those contained in the Performance/STS can be
selected.
• If this lock is closed, Performance/STS FX parameters are left
untouched when choosing an Upper 1 Sound.
• If this lock is open, FX parameters are changed when choosing
an Upper 1 Sound.
Please note that if the effects associated to the selected Sound
are not compatible with the effects already assigned to the FX B
block, the Master FX Send values on the other Keyboard Sounds
will be automatically set to zero.
For example, assume a chorus effect is assigned to the Master 2
FX processor. If the new Sound assigns a distortion effect to the
Master 2 FX processor, the Master 2 FX Send value on the Upper
2, Upper 3, and Lower Sounds will be set to zero, to avoid these
Sounds to sound odd. This way, the Upper 1 Sound (usually the
most important one for solo playing) will sound with the needed
effects, while the other Keyboard Sounds will just sound dry.
Lower When this lock is closed, the Lower Sound remains unchanged
when a different Style, Performance or STS is selected.
This is useful if, for example, you prefer to only play chords with
the left hand, while leaving the Sound in mute.
Keyboard
Mode (Split)/
Accompaniment
When this lock is closed, the status of the SPLIT button (there-
fore of the keyboard mode) remains unchanged when a different
Performance or STS is selected.
This is useful if, for example, you prefer to always play in Full
Keyboard mode, with chords recognized on the full keyboard
range.
To Next Page
Loading...
Need help?
General
